Converter 220V AC to 40kV AC

This device allows up to 40,000 volts by 220V AC. The AC to AC Converter circuit is powered from the mains through primary transformer (220-24) to isolate the network while reducing the input voltage.
Converter 220V AC ke 40kV AC circuit
Here can be used as a fly-back transformer from a TV which is not used. Better to use a primitive type, without tripler or high voltage diode. This type of transformer is initially allowed to obtain ten thousand-volt voltage easily.


First we remove the original primer fly back and build on a new core If the fly-back has a plastic coating or any indication of tripler was built, in this case we have to get other, more old.

Power winding (formed between points C and D) is comprised of ten turns of wire AWG18 with a center tap (ie, five turns, the center tap and five turns over).

The control winding (formed between points A and B) is composed of four turns of AWG22 wire with a center tap (which would be equal to two coils, the center tap and two turns over).

The transistors must be properly dissipated to avoid heat problems of temperature.

We can make this device portable by simply replacing the source of AC-DC with 24V battery.

Attention :

Operating voltage of these devices is high. Harmful to humans, so take extra precautions when handling.



Tags: 220V AC to 40kV AC 40kv ac high voltage power supply ac to ac converter Converter circuit high voltage converter

Related Post "Converter 220V AC to 40kV AC"

Converter 9V to 13.5kV
This high voltage source is formed by
Converter 12 Vdc to 230 Vac or Inverter
As shown in the Inverter circuit diagram
Car Battery Monitor with 3 LED
Car Battery Monitor circuit description: This is
  1. author

    Nat4 years ago

    I dnt understand wht u guys wrote at all. Plc can u guys simplify hw 2 construct invater wit wit a dc output of 220v.

  2. author

    ravikant kushwaha3 years ago

    Dear sir ,
    I am a junior mechanic in electrical . I want to help with you
    I have A transformer With silver winding (in this transformer function in one side amp.increase & Sec.Side volt increase Ex.0-12, 0-24, 0-36 ,0-48, 0-60, 0-72 But I Have Forget This Connection So Please Help me