In the scheme diagram below we present a 0-30V / 5A adjustable symmetrical power supply that can cover a wide range of applications for laboratory or workshop. Values are included in the design diagram.
The potentiometers P1 and P2 used to adjust each regulator output independently to the desired value in the range of 0 to 30V. C5 and C6 of 47 to 100nF capacitors improve the response regulators against switching transients at the output.
Circuit Contruction:
The assembly is small and compact by using a printed circuit board (PCB). You should pay special attention not to reverse the position of the electrolytic capacitors, also not exchange regulators, in practice it can be seen that the pinouts of the two differ, what should be observed closely because their investment destroyed immediately. The transformer according to the line network and by secondary output 5A.
The contact zone between regulators and the heatsink must be isolated and soak special silicone that help dissipate heat on the radiator, take special care to insulate all terminals thereof and which also would be broken because of a short circuit.
The cables must be of sufficient section 2 or 3 mm diameter, not any resistance and avoid brownouts output loading. To control at all times the value of the output voltage supplied by the source, we recommend incorporating into the box, two indicators one branch, as if two voltmeters and ammeters desired as (or galvanometer).
This universal battery charger has regulated output voltage which can be adjusted as you need.…
Here is the auto switch-off power supply which will turn off itself when there is…
This is a high voltage, low current power supply capable to deliver 2000VDC output from…
This is the easy built 15V 1A regulated symmetrical power supply capable to deliver stabilized…
Here we provide a powerful 12V / 3A regulated power supply circuit. Of course the…
If the power supply is damaged or does not work, the computer also will not…