Categories: Battery Charger

12V Nicad Battery charger 200mA/H

This 12V Nicad Battery charger 200mA/H circuit charges the electric battery at 75 mA until the battery is charged, then it cuts down the current to a trickle rate. It’ll fully recharge a dead nicad battery in 4 hours and the battery can be left in the  Nicad Battery charger for a long time.

Setting the shut-off point, connect a 270 ohm, 2-W resistor across the charge terminals and adjust the pot for 15.5 V across the resistor.

Parts list :
R1 : 1K
R2 : 68ohm
R3 : 2K
D1, D3 : 1N752
D2 : 1N4001
T1 : 2N2219
T2 : 2N2222
VR1 : 10K
psu

Share
Published by
psu

Recent Posts

Universal Battery Charger for Charging up to 18V Cell

This universal battery charger has regulated output voltage which can be adjusted as you need.…

5 years ago

Auto Switch-Off Power Supply (Variable Output 3.7V to 8.7V)

Here is the auto switch-off power supply which will turn off itself when there is…

6 years ago

High Voltage, Low Current Power Supply (2000VDC from 15VDC)

This is a high voltage, low current power supply capable to deliver 2000VDC output from…

6 years ago

15V 1A Regulated Symmetrical Power Supply

This is the easy built 15V 1A regulated symmetrical power supply capable to deliver stabilized…

7 years ago

12V / 3A Regulated Power Supply

Here we provide a powerful 12V / 3A regulated power supply circuit. Of course the…

7 years ago

How To Repair Computer Power Supply

If the power supply is damaged or does not work, the computer also will not…

7 years ago