Capacitor C5 and potentiometer R12 figure out the frequency of the output signal at pin number 3 of IC1, the 555oscillator. The output signal is differentiated by C3 and C4 before it’s input to the base of power transistors Q1 and Q2 through diodes D1 and D2, respectively. The signal from IC1 is adjusted to 120 Hertz, because the flip-flop created by transistors Q3 and Q4 splits the frequency by two.
While Q3 is on, the base from Q1 will be connected through R1 to the regulated 12 Volt supply.Then, after theflip-flop changes states, Q4 is activated and the base from Q2 connected to the 12 Volt supply via R2. The 100 mA base current enables Q1 and Q2 to alternately perform via its respective halves to the secondary winding of transformer’s T1.
To reduce switching transients as a result of the fast switching of Q3 and Q4, capacitors C1 and C2 filtering the input to the base of Q1 and Q2 . Electrical power for the inverter get from an car’s 12 Volt system or from a electric battery. The voltage will be regulated by IC2 ( 7812 regulator). LED1, connected over the 12 Volt input, enable you to indicate when electrical power is being given for the inverter circuit. The pilot lamp, LMP1, displays the state of output power.
This universal battery charger has regulated output voltage which can be adjusted as you need.…
Here is the auto switch-off power supply which will turn off itself when there is…
This is a high voltage, low current power supply capable to deliver 2000VDC output from…
This is the easy built 15V 1A regulated symmetrical power supply capable to deliver stabilized…
Here we provide a powerful 12V / 3A regulated power supply circuit. Of course the…
If the power supply is damaged or does not work, the computer also will not…